Sharp 128W Thin Film PV Module, Amorphous silicon/microcrystalline silicon, 186V, NA-V128H1

Please note: Minimum order for all or any combination of solar products is $285.00. Sharp’s thin film product pairs amorphous silicon with a layer of microcrystalline silicon to achieve high stability and performance. Produced with less than one percent of the silicon used in crystalline solar cells, thin film products offer high performance with less semiconductor material. With a low temperature coefficient for output power, thin film generates greater energy than its crystalline silicon counterpart in geographic regions where temperatures are high. In warm climates, this translates into more kilowatt-hours per kilowatt. Engineering Excellence Tandem-junction structure (amorphous silicon/microcrystalline silicon) captures a wider part of the solar spectrum, converting more sunlight into electricity. High Voltage Advantage Proprietary design increases reliability by minimizing losses caused by module output variation. Reliability Microcrystalline layer provides superior long-term stability and higher module efficiency. Durable Four bypass diodes ensure maximum output under non-uniform operating conditions. Innovative Single-layer glass with polymeric backskin lowers pounds per watt and transportation costs. Modules are sized to optimize the greatest amount of power, easily handled by one person. Specifications NA-V128H1 Maximum Power (Pmax): 128 Open-Circuit Voltage (Voc): 238 Short-Circuit Current (Isc): 0.846 Voltage at Maximum Power (Vpmax): 186 V Current at Maximum Power (Ipmax): 0.688 A Module Efficiency (η): 9.0% Temperature Coefficient - Open Circuit Voltage (β): -0.3%/°C Temperature Coefficient - Short Circuit Current (α): +0.07%/°C Made in Japan The electrical data applies under standard test conditions (STC): Irradiance of 1,000 W/m2 with an AM 1.5 spectrum at a cell temperature of 25°C. The power output is subject to a manufacturing tolerance of +10% / -5% Output values are post initial Stabler-Wronski decay; actual measured initial values will be greater (approximately 15% for power). Specifications (I) Cell: Tandem architecture of amorphous and microcrystalline silicon Cell Circuit: 45 cells in series by 6 in parallel per quadrant: 4 quadrants in series (1080 total cells) Dimensions: 39.7" x 55.5" x 1.8" (1009 x 1409 x 46mm) Weight: 42 lbs Connection Type: Cable with MC-4 connector Bypass Diodes: 4 (one per quadrant) Fire Rating: Class C Specifications (II) Maximum System Voltage: 600 Vdc Maximum Mechanical Load: 1,600 Pa Series Fuse Rating: 2 A Operating Temperature (cell): -40 to +90°C Storage Temperature: -40 to +90°C Storage Air Humidity: Up to 90% Installation Orientation: Portrait Design and specifications are subject to change without notice.